I have a sensor/device from another company. In the Channel Setup, the sensor/device is not listed. How do I add it?
You can add a 3rd party sensor or device via
The Activation Code for MR-XP you gave me doesn’t work.
Try the following suggestions: 1) Be sure to enter the
The software is asking for an Activation Code. What number do I enter?
An Activation Key is displayed in myoRESEARCH® XP™ in the
MyoTrace 400: I am getting the error “USB cable is disconnected” in myoRESEARCH® XP™, but my USB cable is connected to the PC Interface and the PC.
This error is usually resolved by installing a patch. If
MyoTrace 400: I charged the myoTRACE 400 battery until its yellow charge indicator was extinguished but the myoTRACE 400 display is not showing 100%.
When the battery is fully charged but the myoTRACE 400
MyoSystem 1400A: I am not getting any auxiliary signals from my 1400A.
Check the toggle switch on the front of the MS1400A
Active Leads: I want to put the reference/ground lead on a bony prominence, but the cable is not long enough.
A “Snap Lead Extender” (part # SLE) is available for
Active Leads: Where should I place the reference/ground lead?
In the past, the recommendation was to place the reference
Active Leads: What is the long wire (snap) on channel 1 for? Do I need to put it on the subject?
The long wire on channel 1 is called the reference/ground.
