How do I remove jumps the software detected from my report?
Refer to the video from our Knowledge Base, linked
I noticed my jump type is listed at the top of the Jump Analysis report. If this is not the type of jump I collected, how do I change it?
The jump type listed is the type of jump
My jumps could not be defined when running a report in MR. What can I do to troubleshoot?
The error is most commonly shown if the Body
What happens if I do not remove jumps related to the error message, “0.5 sec stabilization after jump is missing, impulse-related parameters will be inaccurate,” from my report?
The impulse-related calculations for that jump (e.g. jump height
While running a Jump Analysis report, I am seeing an error message that tells me “0.5 sec stabilization after jump is missing, impulse-related parameters will be inaccurate.
Post-stabilization begins when the landing phase ends. The pre-stabilization
