What is the best way to prepare my sensors when travelling?

Q: What is the best way to prepare my sensors when travelling?

DTS EMG/ myoMotion IMU: Put the sensors into shutdown mode (Click on the home button in the top navigation bar. Then click on the setup button in the upper right corner of the screen. Then click on the configure device button at the bottom right corner of the hardware setup box. Finally, click the “shutdown sensors” button at the bottom of the settings box.) When the sensors are shutdown they will stop blinking completely. The sensors are reactivated by briefly charging them. Place all sensors into the sensor charging station. Position all components inside the system travelling case according to their prepared cavities. Store sensors away from any magnetic material.

DTS EMG/ myoMotion IMU:

Put the sensors into shutdown mode (Click on the home button in the top navigation bar. Then click on the setup button in the upper right corner of the screen. Then click on the configure device button at the bottom right corner of the hardware setup box. Finally, click the “shutdown sensors” button at the bottom of the settings box.) When the sensors are shutdown they will stop blinking completely. The sensors are reactivated by briefly charging them.
Place all sensors into the sensor charging station.
Position all components inside the system travelling case according to their prepared cavities.
Store sensors away from any magnetic material.