DTS Universal Analog Input Sensor
DTS Universal Analog Input Sensor
for Noraxon TeleMyo DTS System
- Accepts non-Noraxon within the specifications require for the Analog Input Probe
- Allows devices with +/- 10V analog signal to be used with the DTS System
- DTS Analog Input sensor can be reviewed in MyoResearch XP
- Small dimensions and very lightweight
Product Overview
The DTS Universal Analog Input Probe accepts non-Noraxon sensors within the specifications required for the Analog Input Probe. This probe gives users the freedom to select the appropriate sensor for their application.
The DTS Analog Input Probe allows a device with +/- 10V analog signal to be used with the DTS system. This sensor gives users freedom to select the appropriate device for their research. The device must be self-powered because the sensor does not provide power to the device attached to it.
The DTS Analog Input is available as a sensor type in MyoResearch XP.
MyoResearch XP Sensor selection screen
Application Examples
The sensor construction guarantees an effective use in a variety of application areas, such as medical research, sports analysis, rehabilitation, ergonomics and robotics. It was designed in order to give freedom to the users to choose any sensor according to their own application.
Analog Probe Mating Connector
Specifications
Sensor:
- 2.5mm mono phone jack, SIGNAL on tip and COMMON on shield.
- +/-10V range
- Accuracy: +/-20mV
- Noise: < 5mV RMS
- Sampling Rate: 1500 or 3000 samples per second
- Input frequency range: 0-500Hz or 0-1000Hz, adjustable
Physical:
- Sensor Length: 1.7 in (4.3 cm)
- Sensor Width: 0.95 in (2.4 cm)
- Sensor Height: 0.55 in (1.5 cm)
- Sensor Weight: 0.8 oz (23g)
Power:
- 3.7 Volts, 190 mAH Lithium Polymer Battery
- Battery Run Time: 8 hours per charge
- Charge Time: < 3 hours
«Back |
