Product Demo

TeleMyo DTS Desk Receiver

Direct Transmission Telemetry
for EMG & Sensors

• Transmits data directly from the electrode site
• Operates EMG and other biomechanical sensors
• Free electrode type selection
• Portable USB receiver
• 4, 8, 12 or 16 channel configuration
• Compatible to existing Noraxon hardware and software
• Simplifies measurements by eliminating connection cables

Product Overview

The TeleMyo™ Direct Transmission System (DTS) for EMG and other biomechanical sensors directly transmits data from the electrode or sensor site to a desktop receiver. This direct transmission concept greatly simplifies the arrangement of EMG measurements by eliminating the need to arrange cable connections between the EMG electrodes and EMG amplifier. The small light weight probes are also beneficial for small subjects like children and small animals.

The DTS system can operate any configuration between 4 and 16 channels. The default system is equipped with EMG preamplifiers but can be upgraded with other biomechanical sensors like goniometers, inclinometers, and foot switches. A wireless synchronization system can be used to accurately synchronize the TeleMyo DTS System to other biomechanical devices.

Unique Items

• Noraxon's superior signal quality
• Complete line of wireless biomechanical sensors
• Precise and flexible wireless synchronization trigger system
• Easy installation: no drivers to install

DTS Probe and Desk Receiver Specifications

Desk Receiver Specifications

• Up to 16 sensor channels
• USB connection to PC
• TTL 5V sync input
• TTL 3.3V sync output
• 16 Analog Outputs via DB-25 connector
• External Antennas

Power Requirements

• 5V 800mA

Output & Transmission Frequency (Depending on country)

• Up to 2.5 mW (depending on country allowance)
• DSSS 2403-2472 MHz on (up to) 5 selectable radio channels
• DTS Probe transmission range: 30m (may vary based on wireless conditions)

EMG Sensor Data Acquisition System

• 16-bit resolution
• Selectable low-pass cutoff: 500Hz or 1000Hz (Analog Outputs have fixed 500Hz cutoff)
• Selectable Sample Rate: 1500Hz or 3000Hz

EMG Preamplifier Leads

• No notch (50/60 Hz) filters are used
• 1st order high-pass filters set to 10 Hz +/- 10% cutoff
• Baseline noise < 1 uV RMS
• Input impedance > 100 Mohm
• CMR > 100 dB
• Input range +/- 6.3 mV
• Base gain 200
• Final gain 500
• Snap-style or Pinch-style terminal electrode connections

Dimensions

• EMG Probes Dimensions: 1.34" L x 0.95" W x 0.55" H (3.4 cm x 2.4 cm x 1.4 cm)
• EMG Probes: Weight: Less than 14 g.
• DTS Desk Receiver Dimensions: 7.75" L x 11.5" W x 2.5" H
  (19.7 cm L x 29.2 cm W x 6.4 cm H)
• DTS Desk Receiver Weight: 2.4lb (1.1kg)

View Specs » (PDF)

«Back